How It Works
In aerospace assembly, a fastener done by feel isn't good enough. Three steps, every time:
SET
Target torque & OK/NG limits
FASTEN
Auto stop at target torque
VERIFY
OK / NG instantly, logged to your PC
Read Every Result at a Glance
Green = OK, red = NG, with a beep.
Shown after every cycle.
Within your upper and lower limits?
Fasteners done in this group.
Set target, limits, speed and angle.
Auto Shut-Off at Target Torque
Built-in transducer stops the tool at your target — one-step fastening for M3–M10.
Easy to Set Up
Torque or angle strategy, 4 torque units, and 80–120% calibration to match your torque tester.
Light & Compact
Under 3.3 lb with battery, 8.11 in long. Less fatigue over long shifts.
Built to Last
Cordless 20V with LED work light and a maintenance alert at 200,000 cycles.
Precision · Data · Lightweight
Connect, Record, Export
Every fastening becomes a record your quality team can keep.
Plug & Play
No complex installation or training.
Live Monitoring
Watch results and tool status in real time.
Data Archiving
Up to 1,000 records, export to CSV.
Cost-Effective
Built for smaller shops, MRO and project work.
Typical Aerospace Applications
Built for M3–M10 fasteners in the 1–18 Nm (8.9–159 in-lb) range.
Electrical & Sub-Assemblies
Clamps, connector hardware and small bench assemblies.
MRO & Ground Support
Repeatable, recorded torque for maintenance and repair work.
Choose Your Model
| Model | Torque (Nm) | Torque (in-lb) | Programmable Speed | Drive |
|---|---|---|---|---|
| RV2056-WR8 | 1–8 | 8.9–70.8 | 50–1,200 rpm | 1/4" Hex Shank |
| RV2056-WR18 | 3–18 | 26.6–159.3 | 50–800 rpm | 1/4" Hex Shank |
Both models: 20V DC; under 3.3 lb (1.5 kg) with battery; 206 mm (8.11 in) long, 236 mm tall. Compatible with Durofix 20V batteries B2036LA / B2036LB / B2036LA-2 / B2036LB-2 and charger DC20US28-C30.
FAQ
Is the RV2056-WR approved for aerospace use?
Tool approval depends on your own process and quality requirements. We can provide full specifications and the product manual to support your evaluation.
Can I keep a record of each fastening?
Yes. With the Durofix USB dongle connected to a PC, you can monitor results in real time, record up to 1,000 fastenings and export them as CSV.
Can I check accuracy against my own torque analyzer?
Yes. The calibration coefficient can be adjusted from 80% to 120% (default 100%) to match your torque tester.
Which model should I choose?
Choose the WR8 for small screws up to 8 Nm, or the WR18 for up to 18 Nm. Not sure? Send us your fastener specs and we'll recommend one.
Do you offer volume pricing?
Yes. For production lines and MRO shops, use our Request a Quote form for bulk pricing.
What warranty is included?
The RV2056-WR includes a 1-year limited warranty.
Suitability and torque values should be verified for each application. Specifications subject to change without notice.